Autoclaves KT – ALP is one of the best selling products in INNOTEC – The company specializes in the line of autoclaves nationwide .
The CAP system autoclaves KT – ALP
- The lid can be opened and closed with just a gentle hand, but still safe because there are six rubber cushion handles and closes, ensure the safety for the user to accidentally open the lid when the pressure in the Chamber of the autoclaves KT – ALP
- The handle of the lid grip design and named Hexagon, When the steam exit opening will ensure safety for users
- The door of the Chamber was designed to top and just the right height for easy use and space use
Automatic operation
- Just close the discharge valve and set the timer, autoclave will operate completely automatically
- Automatic exhaust valve ensure sterilization.
- The timer only starts the operation after reaching a pressure of / the installed temperature, and stop when the finished disinfection activities .
- Automatic pressure / adjust the temperature
Set disinfection temperature a touch
- Before the operation, You can select and set temperature sterilization button on the control panel. Sterilization temperature varies depending on the model (usually on about 110-121theC)
Prevention of water deficiency
- Regulators heat sensor will disconnect the power immediately in case of lack of water and has a constant signal tone and active again when reset time again
Safety lid
- The safety CAP is designed to prevent burns that you encounter during the work. grasp of the lid flexes are mounted diagonally of hand grip
Safe when used autoclaves KT – ALP
- Air Chamber of autoclaves KT – ALP come from Japan made of stainless steel SUS-304, the compression chamber lid with pressure and are tested through water pressure (water pressure is reached 0.36 Mpa)
- Safety valve operates at a pressure of 0.18 Mpa, in the case of abnormal pressure increases, the safety valve will drain and the machine stops operating
- The pressure regulator and with the parts with high confidence after years of testing
- Will the safety breaker switches off the power source in case of short circuit, so the line or when there is trouble power leak
Advanced flushing system
- Chamber exhaust will be emitted when the discharge valve open, at the moment can sterilize the easy way
- Large diameter exhaust valve may discharge dust and dirty water in the bottom Chamber, keep the inner Chamber is always clean
The sturdy drying system
- The hearth of autoclaves KT-ALP made of fiberglass insulation, make sure to dry the wet material's level while the pasteurization
- The drying process is done by adjusting the valve to discharge effluents after completion of the sterilization Chamber bottom inner water to flow out, moving from the "sterilization" mode to "drying" and adjust the timer to install drying time
- The time starts counting after the temperature inside the Chamber reaches the drying temperature
Above is the product autoclaves KT – ALP was sold in INNOTEC VIETNAM . All requested quotes and technical support, please contact Hotline : 0937269888 . Sincerely thank !
Central Germany – :
quotes for yourself this product !